Gallery

ISD1820 voice board sound recording recorder Playback module microphone

recording sound ISD1820  2

recording sound ISD1820  3

recording sound ISD1820  5

recording sound ISD1820  4

recording sound ISD1820

Our ChiOSZ Products

ISD1820 voice board sound recording recorder Playback module microphone Arduino projects Robots NEW

Description
This module is base on ISD1820, which a multiple-message record/playback device. It can offers true single-chip voice recording, no-volatile storage, and playback capability for 8 to 20 seconds. The sample is 3.2k and the total 20s for the Recorder.
This module use is very easy which you could direct control by push button on board or by Microcontroller such as Arduino, STM32, ChipKit etc. Frome these, you can easy control record , playback and repeat and so on.
Features:
•Push-button interface, playback can be edge or level activated
•Automatic power-down mode
•On-chip 8Ω speaker driver
•Signal 3V Power Supply
•Can be controlled both manually or by MCU
•Sample rate and duration changable by replacing a single resistor
•Record up to 20 seconds of audio
•Dimensions: 37 x 54 mm
If you want change record duration, an external resistor is necessary to select the record duration and sampling frequency, which can range from 8 – 20 seconds (4-12kHz sampling frequency).
The Voice Record Module of our provide default connect 100k resistor through P2 by short cap. So the default record duration is 10s.
1.PLAYE – Playback, Edge-activated:When a HIGH-going transition is detected on continues until an End-of-Message (EOM) marker is encountered or the end of the memory space is reached.
2.REC – The REC input is an active-HIGH record signal.The device records whenever REC is HIGH. This pin must remain HIGH for the duration of the recording. REC takes precedence over either playback(PLAYL or PLAYE) signal.
3.Speaker Outputs – The SP+ and SP- pins provide direct drive for loudspeakers with impedances as low as 8Ω.
4.MIC – Microphone Input, the microphone input transfers its signals to the on-chip preamplifier.
5.REPLAY – loop play the record.
6.FT – Feed Through: This mode allows use of the speaker drivers for external signals.
7.ISD1820 – IC chip
8.Lead Out IO – VCC LED NC FT GND / VCC REC PLAYE PLAYL GND
9.P2 – default short connection ROSC to 100kΩ resistance, that’s means record duration is 10s
10.PLAYL – Playback, Level-activated, when this input pin level transits for LOW to HIGH, a playback cycle is initiated.
Record Operate Guide
1.Push REC button then the RECLED(D1) will light and keep push until record end.
2.Release the REC button
3.Select Playback mode: PLAYE, just need push one time, and will playback all of the record or power down ; PLAYL, you need always push this button until you want to stop playback record or end ; REPEAT, switch 5 to right side, and the record will playback time a time until switch to light or power down
4.FT mode, when you switch 6 to right side, that means all of you speak to MIC will direct playback from Speaker.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s