Combo XBee 2mW Wire Antenna – Series 2 (ZigBee Mesh) Arduino projects robots NEW
XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.
Note: Series 1 and Series 2 XBee modules have the same pin-out. However, Series 1 modules cannot communicate with Series 2 modules.
3.3V @ 40mA
250kbps Max data rate
2mW output (+3dBm)
400ft (120m) range
Fully FCC certified
6 10-bit ADC input pins
8 digital IO pins
Local or over-air configuration
AT or API command set
Kit Breakout Board for XBee Module
This board breaks out all 20 pins of the XBee to a 0.1″ standard spacing dual row header. The spacing between 0.1″ headers is 0.5″ making it breadboard DIP – Dual In line Package, 2 x female sockets, 2 x headers.