NRF24L01 2.4GHz Wireless Transceiver and Smart Shield Module

nrf24l01 chiosz robots 8 pin 9

nrf24l01 chiosz robots 8 pin 11

NRF24L01 shield chiosz robots 00

NRF24L01 shield chiosz robots 2

NRF24L01 shield chiosz robots 4


NRF24L01 shield chiosz robots 22

NRF24L01 shield chiosz robots 33

NRF24L01 shield chiosz robots 44


NRF24L01 shield chiosz robots

Our ChiOSZ products

NRF24L01 2.4GHz Wireless Transceiver and Smart Shield Module NEW

1.Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications.

2.125 Channels, Multi-point communication and frequency hopping to meet the communication needs

3.Built-in hardware CRC error detection, Multipoint communication address control.

4.Low-power 1.9 ~ 3.6V, only 1uA on Power down mode

5.Built-in 2.4Ghz antenna

6.Available software to set the address, only received local Address when output data (Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient.

7.Built-in voltage regulator

8.Standard DIP Pitch Interface for embedded applications

9.size: 34mm X 17mm X 1mm

NRF24L01 Wireless Shield SPI to IIC I2C TWI Interface Arduino projects robots NEW

Wireless module for NRF24L01:

I2C (TWI) communication protocol is used, which simplifies the NRF24L01 communication process greatly, users no need to understand the tedious communication process of NRF24L01,it improves the efficiency of project development Immensely by this way.

Each module will be as a slave ofI2C (TWI).(address 35)
Module is in a small frame with length 73mm,width 22mm.
Smooth bidirectional communication and no discernable the slave or master.
Maximum transmissive distance can reach 70m(Just for reference)
Wireless corresponding chip is reliable NRF24L01communication protocol,it will reduce data lost.
I2C/TWI protocol simplifies the communication lines greatly.
Compatible with arduino perfectly.


Robot control, remote control.,Information collection, etc.

Note: The wireless communications may result in radiation, so it is not recommended for life protection area.


Operating voltage: 5V.

(No short-circuit protection,so you must be careful with polarity connection when you use.)

Hold time of module receiving data :more than 2S
Hold time of module transmitting data:more than 300s
Transfer rate:50Byte/S (theoretical value)
I2C/TWI Address:0x47 (decimal 35)
NRF24L01 Address:0x34, 0x43, 0x10, 0x10, 0x01 (from low to high)

Related terms:

Hold time of module transmitting data means when the module (TWI slave) receives data sent from master, it will transmit the date to another module, and then it will wait to receive another response signal of that module,if there is no response signal after a while,the module will send the data again,repeated sending times multiply waiting time is the hold time.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s